deepSilverAccoun tLogo

Wimax Bpenum May 2026

Use a tool like Iperf behind the subscriber module. Observe the standard deviation of delay (jitter). Jitter > 50ms often indicates BPeNUM scheduler congestion.

The second half of the keyword, NUM (Number of Users Multiplexed), deals with the scheduler’s capacity. It answers the question: Given a fixed frame size and BPeNUM split, how many subscribers can be actively served simultaneously? wimax bpenum

False. Tools like Ekahau, Tektronix, or Rohde & Schwarz WiMAX scanners can measure the effects of poor BPeNUM (high jitter, low throughput) but cannot auto-tune it. BPeNUM remains a manual configuration set by an expert engineer based on traffic forecasts. Use a tool like Iperf behind the subscriber module

The Scenario: A South American rural ISP deployed a WiMAX 802.16e network (Mobile WiMAX) for 500 fixed subscribers. Speeds plummeted during peak hours from 8 Mbps to 0.5 Mbps. Latency jumped to 2000ms. The Scenario: A South American rural ISP deployed

The Diagnosis: A contractor had set the BPeNUM partitioning to a static 50/50 (DL/UL) with no per-service flow limits. The "NUM" (multiplexing) was allowing 150 active users to share the same best-effort queue.

The Fix (BPeNUM Re-engineering):

  • Capped NUM per partition: Enforced a maximum of 40 users in Partition B. Additional users fell back to Partition C with a lower Minimum Reserved Rate.

    • The Result: Subjective speeds rose to 6 Mbps peak, and the "death spiral" was eliminated. The base station went from 100% CPU utilization (due to grant renegotiation storms) to 55%.